1TX3
Airport
Beggs Ranch
Guthrie, Texas

FAA NFDC Information Effective 56-day cycle 07/24/2014 - 9/18/2014

Ops Comms Services Owner Runways IFR Procs Current NOTAMs Remarks

Location

FAA Identifier:1TX3 (One-Tango-Xray-Three)
Lat/Lng: 33.4250869444, -100.542061389
33-25-30.3130N, 100-32-31.4210W
Estimated
Elevation: 1870 feet Estimated
Magnetic Variation: 08E, (1985), [6E (2014)]
Sectional: DALLAS-FT WORTH
From City: 17nm SW of Guthrie

Operations

Use: Private
Ownership: Privately owned
Activation: 04/1961
Control Tower: no
ARTCC: Fort Worth Center (ZFW)
FSS: Fort Worth FSS (FTW)
Wind Indicator: None
Landing Fee: no

Communications

Services

Airframe Repair: None
Powerplant Repair: None

Based Aircraft

Total: 0

Annual Operations

Total: 0

Ownership

Owner: George Beggs Trust
306 W. 7Th Street, #644
Ft. Worth, Tx 76102
817-336-9727
Manager: G. Beggs, Iv
306 W. 7Th Street, #644
Ft Worth, Tx 76102
817-336-9727

Runways

Runways: 04/22

Runway 04/22

Length: 4000 feet
Width: 50 feet
Surface: Grass / Sod
End 04 End 22

Procedures

NOTAMs

Additional Remarks

Watch for Cattle on Runway.

This information is current as of the date at the top of the page. These pages are valid for all US airports, based on information from FAA National Flight Data Center. Weather information is provided based on AvnWx Data Sources. NOTAM information is from FAA's NAIMES data portal.

As with most information on this website, this page is generated based on FAA data, with automatic translations done via computer. You can also directly read the A/FD via the green icon link at the top of the page, which is the FAA text, and sometimes provides a different translation of codes. Please email me (using link at top-right of this page) if you see information which is confusing, misleading, or wrong....Or have suggestions for additions/changes.

Comments from the user community are clearly noted as such this page, are for informational purposes only, may be wrong and/or out-of-date, and must not be used as a sole source for critical decision making. See Privacy Policy and Conditions of Use.