St Luke's Magic Valley
Twin Falls, Idaho

FAA NFDC Information Effective 56-day cycle 08/17/2017 - 10/12/2017

Ops Comms Services Owner Runways IFR Procs Current NOTAMs Remarks


FAA Identifier:80ID (Eight-Zero-India-Delta)
Lat/Lng: 42.5908333333, -114.496111111
42-35-27.0000N, 114-29-46.0000W
Estimated by OWNER on 04/20/2011
Elevation: 3686 feet Estimated by OWNER on 04/20/2011
Magnetic Variation: [13E (2017)]
From City: 2nm NW of Twin Falls


Use: Private
Ownership: Privately owned
Activation: 07/2011
Attended: Continuous
Control Tower: no
ARTCC: Salt Lake City (ZLC) Salt Lake City Center (ZLC)
FSS: Boise FSS (BOI)
Wind Indicator: Lighted
Landing Fee: no



Based Aircraft

Single Engine GA: 1
Helicopter GA: 1
Total: 2

Annual Operations

Total: 0


Owner: St. Luke's Magic Valley
801 Pole Line Road
Twin Falls, Id 83301
Manager: Blaine Patterson
801 Pole Line Road
Twin Falls, Id 83301
(208) 308-4155


Runways: H1

Runway H1

Length: 50 feet
Width: 50 feet
Surface: Porland Cement Concrete



Additional Remarks

(Contact Title) Mike Fenello - Site Admin - Twin Falls Campus - 208-814-1000

This information is current as of the date at the top of the page. These pages are valid for all US airports, based on information from FAA National Flight Data Center. Weather information is provided based on AvnWx Data Sources. NOTAM information is from FAA's NAIMES data portal.

As with most information on this website, this page is generated based on FAA data, with automatic translations done via computer. You can also directly read the A/FD via the green icon link at the top of the page, which is the FAA text, and sometimes provides a different translation of codes. Please email me (using link at top-right of this page) if you see information which is confusing, misleading, or wrong....Or have suggestions for additions/changes.

Comments from the user community are clearly noted as such this page, are for informational purposes only, may be wrong and/or out-of-date, and must not be used as a sole source for critical decision making. See Privacy Policy and Conditions of Use.