NR28
Heliport
Spivey's Corner Fd
Dunn, North Carolina

FAA NFDC Information Effective 56-day cycle 04/18/2024 - 6/13/2024

Ops Comms Services Owner Runways IFR Procs Current NOTAMs Remarks

Location

FAA Identifier:NR28
Lat/Lng:35.1969661111, -78.4846602778
35-11-49.0780N, 078-29-04.7770W
Estimated by Owner on 09/17/2020
Elevation:192 feet Estimated by Owner on 09/17/2020
Magnetic Variation:09W,(2025), [-10W (2024)]
Sectional:CHARLOTTE
From City:9nm SE of Dunn

Operations

Use:Private
Ownership:Privately owned
Activation:09/2020
Control Tower:no
ARTCC:Washington(ZDC)Washington Center
FSS:Raleigh FSS(RDU)
Wind Indicator:Lighted
Landing Fee:no

Communications

Services

Based Aircraft

Helicopter GA:1
Total:1

Annual Operations

Total:0

Ownership

Owner:Spivey's Corner Volunteer Fire Dept
8200 Newton Grove Hwy
Dunn, Nc 28334
910-385-8397
Manager:Alan Honeycutt
8200 Newton Grove Hwy
Dunn, Nc 28334
910-385-8397

Runways

Runways:H1

Runway H1

Length:40 feet
by Owner on 09/17/2020
Width:40 feet
Surface:Porland Cement Concrete
Surface Treatment:NONE

Procedures

NOTAMs

Additional Remarks


This information is current as of the date at the top of the page. These pages are valid for all US airports, based on information from FAA National Flight Data Center. Weather information is provided based on AvnWx Data Sources. NOTAM information is from FAA's NAIMES data portal.

As with most information on this website, this page is generated based on FAA data, with automatic translations done via computer. You can also directly read the A/FD via the green icon link at the top of the page, which is the FAA text, and sometimes provides a different translation of codes. Please email me (using link at top-right of this page) if you see information which is confusing, misleading, or wrong....Or have suggestions for additions/changes.

Comments from the user community are clearly noted as such this page, are for informational purposes only, may be wrong and/or out-of-date, and must not be used as a sole source for critical decision making. See Privacy Policy and Conditions of Use.